PLC Controlled Vacuum Pressure Impregnation Equipment VPI 2800 * 3500 mm
Introduction
High vacuum pressure impregnation equipment is the key equipment for insulation treatment of high voltage motors, special
anti-explosion motors, and transformers. The vacuum impregnating treatment enhances the mechanical strength, insulation,
anti-moisture and anti-mold performance of the windings.
Installation, test-running and training is provided on the buyer’s site. The foundation drawing is also provided.
Parameters :
Vacuum Pressurizing Impregnation Equipment Tank 1 Set
| pressurizing and impregnating tank, specification: Φ2800×3500mm, 1 piece; head: 16MnR; tank body material: Q345-R; flange: Q235-B forged parts; working pressure: 0.6MPA; working vacuum degree: 500-1000Pa; |
Features
The impregnating tank cover is opened and closed with the help of a hydraulic mechanism. The signal is feedback through
non-contact proximity switch. The tank cover opening angle follows the rule that the top point of the opened cover passes
over the inner wall of the impregnating tank.
The impregnating tank is equipped with a level transmitter.
The impregnating tank is equipped with an over-pressure alarm, and a pressure safety device.
The impregnating tank is designed with one anti-explosion peephole light and one observation window.
The impregnating tank is sealed by a silicon rubber ring.
When the impregnating tank cover is opened, the tank has safety interlock mechanism.
The resin is supplied into the impregnating tank through the tank bottom.
The vacuum pressure impregnation system tank is built with a weight bearing stand which can tolerate 30ton.
The impregnating tank is a vertical type.
The impregnation tank is equipped with a camera so as to check the inside working performance.
Supply Scope
| 1. Vacuum pressure impregnation equipment tank, 1 set; 2. Resin storage tank, 1 set; 3. Vacuum system, 1 set; 4. Hydraulic system, 1 set; 5. Pneumatic system, 1 set; 6. Pressurizing system, 1 set; 7. Resin cooling system, 1 set; 8. Resin heating system, 1 set; 9. Resin supply and return system, 1 set; 10. Electrical control system, 1 set; |
Youtube link of vacuum pressure impregnation equipment
https://youtu.be/EWkfmRQbxHE
